Virtual Valve Museum
Virtual Valve Museum | search: (use * for wildcard)
About the museumMuseum exhibitsUpdates, new exhibits etc.EquipmentSupporters
*DocumentsValves wanted!Valves for sale or for tradeLinks to other sites, suppliers etc.

Trigatron

A trigatron is a triggered spark gap which is typically used in radar modulators to feed the large pulse necessary to a magnetron. Trigatrons operate either in air or are sealed.

It consists of three electrodes, two of similar size, one of which has a third electrode held in a hole drilled through its middle. The undrilled electrode is negative with respect to the other two. The other two are normally at the same potential. When a trigger pulse is applied to the trigger electrode it causes the main electrodes to conduct.

Open air trigatrons could not be used at the low pressures encountered at high altitudes. After experiments with construction techniques and gas mixes a filling of a pressurised argon/oxygen mixture was selected with approximately 93% argon and 7% oxygen.

Type
CV85

CV100

CV125
Pulse energy (kW) 170 250 500
Pulse duration (µs) 1 2 1
Network voltage (kV) 7.2 16 12
Pulses/sec 1200 400 800
Gap length (cm) 4 6 6
Argon pressure (PSI) 45 65 55
Trigger voltage on-load (kV) 3 5 3.5
Starting voltage (kV) 2.5 5 5.5
Operating range (kV) 5 to 13 8 to 24 8 to 22
Life (hours) 400 2000 800
(A later version of the CV85 with 65 PSI Argon and 4.5% oxygen had a life of 600 hours)

The woven protective 'sock' protects from explosion due to the pressure of gas inside these devices, though the bursting pressure of the bulbs is quoted at 300 PSI.

This file was last modified 15:56:30, Tuesday September 02, 2014